Kmc-controls BAC-8007 Installation Guide Uživatelský manuál stáhnout pdf (Strana 38)

Procedure Steps STE display

3 Change Password 1.

Note: Entering four zeros (0000) removes the

password.

1.

Press the or buttons to change the first

digit.

2.

Press the

Set

Point

button to select the next digit.

Repeat for all four digits.

3.

When the

Set

Point

button is pressed for the last

digit, the new password is saved and the

display advances.

PSW1

OOOO

4 Change Password 2.

Note: Entering four zeros (0000) removes the

password.

1.

Press the or buttons to change the first

digit.

2.

Press the

Set

Point

button to select the next digit.

Repeat for all four digits.

3.

When the

Set

Point

button is pressed for the last

digit, the new password is saved and the

display advances.

PSW2

OOOO

5 Set the local unoccupied

override timer.

Applies only to STE-6017

sensors.

1.

Press the or buttons to set the local

unoccupied override timer. The value will

change in 1 minute increments.

2.

Press the

Set

Point

button to save the setpoint and

advance to the next function.

3O

OVRD

6 Set the standby time

Applies only to STE-8201

sensors.

1.

Press the or buttons to set the time for

the standby time. The value will change in 1

minute increments.

2.

Press the

Set

Point

button to save the setpoint and

advance to the next function.

15

7 Set discharge air

temperature limiting.

Not used for all models.

Required for reheat.

1.

Press the or buttons to enable or disable

discharge air temperature limiting.

2.

Press the

Set

Point

button to save the setpoint and

advance to the next function.

DISABLE

DAT

Procedure to set the advanced options (continued)

Section 4: Configuring the controllers SimplyVAV

38 Revision E

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 87 88

Komentáře k této Příručce

Žádné komentáře