Kmc-controls CTE-1101 Uživatelský manuál stáhnout pdf

CTE-1001/1002/1101 1 Installation Guide

Installation Guide

Single Setpoint Room Thermostats

CTE-1001/1002/1101

Mounting

Wiring

Refer to the diagram above for screw terminal loca-

tions.

T3 is not restricted by the minimum and maxi-

mum control points. See the diagrams on the next

page. Typically in KMC thermostats, T1 and T3 are

used for cooling, and T2 and T4 are used for heating.

NOTE: Only CTE-1101s have the A terminal that

is used for temperature averaging. See the

Temperature Averaging section on the next

page.

Mounting 1

Wiring 1

Temperature Averaging 1

Important Notices 2

Maintenance 2

Standard:

• The base unit’s mounting slots are designed to

align with the holes in a standard 2" x 4" (51 x 102

mm) handy conduit box. Use such a box if using

conduit.

• On solid walls, normal screw and anchor systems

may be used.

NOTE: Seethedatasheetforacompletelistingof

accessoriesaswellasspecications.

Hollowwall:

1. Cut a 3-3/4" x 1-3/4" rectangular opening in the

wall. (Check if unit is horizontal or vertical before

cuing.)

2. Make all necessary connections.

3. Insert an HMO-5001 Toggle Bolt Assembly

(ordered separately) through the wall and tighten.

All dimensions are in inches (mm).

NOTE: Careshouldbetakennottobendorex

thebaseofthethermostat.

1 2

Shrnutí obsahu

Strany 1 - Installation Guide

CTE-1001/1002/1101 1 Installation GuideInstallation GuideSingle Setpoint Room ThermostatsCTE-1001/1002/1101MountingWiringRefer to the diagram above

Strany 2 - Temperature Averaging

Příbuzné modely CTE-1002 | CTE-1001 |

Komentáře k této Příručce

Žádné komentáře

Kmc-controls CTE-1101 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Senzory Kmc-controls CTE-1101. KMC Controls CTE-1101 User Manual Uživatelská příručka

Shrnutí obsahu

Příbuzné modely CTE-1002 | CTE-1001 |

Komentáře k této Příručce

Související produkty a manuály pro Senzory Kmc-controls CTE-1101